Anchor-Dit (2oz. size)
When making a mold of an object, it is often necessary to adhere the object to the work surface. When making food grade molds, conventional adhesives should not be used due to toxicity and also due to the fact that they can inhibit the proper cure of food grade silicone.
How to Use Anchor-Dit™
Click the pictures below to enlarge.
Anchor-Dit™ is a food grade, temporary adhesive that is used to adhere an object to a work surface so that silicone mold making materials do not creep underneath it and interfere with the making of a good quality mold. Anchor-Dit™ also binds a buoyant object to a work surface so that it does not float when liquid silicone is poured over it.
Apply Anchor-Dit™ about a 1/16” to the bottom of the object and press the object down on a work surface so that the Anchor-Dit™ “smooshes” out all sides.
Wipe the excess Anchor-Dit™ away from the edges of the object with a soft cloth or a dry, firm bristled brush.
In this example, Silicone Plastique® is applied to the Anchor-Dit™ mounted object and also to an object where Anchor-Dit™ was not used.
In each of these images, the mold on the left was made using Anchor Dit™ and the mold on the right was made without Anchor Dit™. Notice how the opening of the left mold mold is clean, square cornered and without “flash” which refers to the thin seepage of silicone that found its way underneath the object.
Image on the left captures a properly made mold using Anchor-Dit™ and liquid silicone. Image below shows how unanchored, buoyant objects can float in liquid silicone and ruin almost any mold making project.
|Dimensions||1 × 1 × 1 in|